Owner's manual

6 1-800-732-2677
Operating Guide
Prepare the Receiver Collar
Your Receiver Collar comes with Contact Points installed. Tighten the
Contact Points using the Test Light Tool to one-half turn beyond fi nger
tight (1A). Check the tightness weekly.
To Insert and Remove the Battery
1A
Note: Do not install the battery while the Collar Receiver is
on your pet.
Remove the screws with a Phillips screwdriver.1.
Remove the Battery Lid (2. 1B).
Install a 9-volt alkaline battery (3. 1C).
Replace the Battery Lid (4. 1C).
Reinstall the screws.5.
Do not over-tighten the screws.
1B 1C
Replacement 9-volt alkaline batteries can be found at many retailers.