Owner's Manual

Remove the faceplate.
Insert the pump into the foam filter and set
both down into the square inside the bowl.
Press down so the suction cups attach.
Wash these parts with soap and warm water, then put the pump back together. Rinse all parts of the fountain in cold water except the cord
and power adaptor.
Remove the stator.
Feed the cord down into the tube and
out through one of the notches on the
bowl’s base.
Remove the impeller.
Insert the silicone cap and fold its top edge
down over the top of the tube. This holds the
cord in place and prevents leaks.
1 2
Clean the pump before you assemble the fountain: Install the foam filter and the pump:
Setup instructions