Owner's Manual

6 Customer Care Center [phone]
2
2. Remove the blue teardrop shaped stator by
pulling up on the small lip.
1
Assemble Pet Fountain
Note: Rinse all fountain components (except for
the adaptor) with warm water before using the
pet fountain. This will remove any residue from the
manufacturing process.
1. Take the pump apart by first removing the blue
faceplate. Use your finger to pull up on the
small tab.
3
3. Use a fingernail to pull out the impeller,
which is held in place magnetically. Clean
the pump parts with warm water and soap,
then reassemble.
4
4. Rinse the carbon filter thoroughly under cold
water to remove any loose carbon dust. Insert
the filter into the filter housing with the larger side
facing down.