Owner's Manual
Fountain Reassembly
1.
2.
3.
4.
5.
6.
Replace the Pump
by
aligning
the
unit into
its
fitted space inside
the
Bowl (Fig. 12). The suction
cups
on
the Pump should be facing
down and the Flow Control Knob facing into the Bowl. Gently push
down
to
engage suction cups.
Thread
the
In-Line Plug
of
the electrical
power
cord through
the
hole located next
to
Pump and push the rubber gasket firmly
into
the
hole.
To
insure the fountain Bowl is stable, run the electrical
power
cord
along the
"cord
channel" and through
the
notch
in
the
base
of
the
fountain (Fig. 13).
Attach
the
Housing
by
sliding the
cutout in the wall
of
the Housing
down over
the
Flow Control Knob.
The Housing will click into place
when
the
side
tabs
are inserted in the
Bowl
(Fig. 14).
Replace
the
Charcoal Filter, with the
black side facing the front
of
the
fountain towards the spout.
Fill the Bowl with water and replace
the Housing Lid.
Place fountain in desired location. Do
not
pick
up
a full fountain
by
the
Housing. Only
pick
up
the
fountain
by
placing both hands underneath the base
of
the
fountain and grip the sidewalls
for
a sturdy hold.
Important:
To
protect
your
floor
always
use a protective mat such
as
a towel
or
water-resistant placemat. This will help protect
your floor from any splashing
or
spills caused by
your
pet.
7. Before you plug in the fountain make sure the electrical
power
cord,
the
adaptor
and
your hands are dry. Connect the In-Line Plug and makes sure
no
silver is showing then
plug the adaptor
into
a standard electrical wall outlet.
Attaching Additional
Capacity
Reservoir
(available accessory)
The additional Capacity Reservoir easily attaches
to
the
back
of
the Drinkwell® Original Fountain
to
increase the
fountain's overall capacity and make refills easier. With
the
use
of
the 50
oz
Reservoir, the fountain's total capacity
increases
to
1 00 oz.
INSTRUCTIONS:
1. The base, which
supports
the reservoir container, has
two
tabs
that slide over
the
opening
at
the
back
of
the
fountain (Fig. 15).
2. Place the fountain in a desired location. If placing on
carpet, tile
or
wood
flooring, always place a protective
mat
or
other durable, water resistant surface underneath
the
fountain.
Hook
the
two
tabs
of
the
base over the rear
wall
at
the
back
of
the fountain (Fig. 16). The base
must
be properly attached
to
avoid spills when the reservoir
is added.
If
you have an active household,
do
not
place
the
fountain in an area where
the
reservoir can easily be
knocked over.
3. Remove
the
lid and fill
the
reservoir with fresh water.
4. Make sure
the
0-ring
rests flat inside
the
groove
of
the
lid, this creates an airtight seal. Replace the lid.
Tabs
Fig.
16
5. Hold the reservoir over
the
base with the
spout
farthest
away from
the
fountain. Quickly turn
the
reservoir upside
Tabs
hook
over
rear
wall
10
Customer Care Center
1-800-732-2677