Owner's Manual

10 Customer Care Center 1-800-732-2677

Set Up the Threshold Transmitter

To prevent an unintended correction, never perform set-up procedures while your pet is wearing the Receiver Collar.

1. Turn over the Threshold Transmitter and remove the battery door. Install four AAA alkaline batteries

(2A) and replace the battery door.

2. Slide switch on back of Threshold Transmitter to Training Mode until your dog has

learned his boundary.

Turning the Threshold Transmitter ON

Turn the Threshold Transmitter right side up. Press and hold the Mode Button until the Green LED

indicator is ON. Release the button and the Green LED indicator turns OFF. The Red LED will then ﬂash

the Transmitter level setting between 1 and 4 times.

Turning the Threshold Transmitter OFF

Press and hold the Mode Button until the Green LED turns OFF.

Setting the Transmitter Levels

Momentarily press and release the Mode Button. The Green LED will ﬂash when pressed. The current setting will ﬂash Red. Press the Mode

Button again within 5 seconds. The level will increase by 1 level. If the current level is 4 it will revert to level 1.

Step