pawz away threshold pet barrier ® operating and training guide Model Number PWF00-14406 PLEASE READ THIS ENTIRE GUIDE BEFORE BEGINNING
Important Safety Information Explanation of Attention Words and Symbols used in this guide This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death. WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
This System is NOT a solid barrier. The system is designed to act as a deterrent, using Static Correction to condition pets to remain outside of the established barrier area. It is important that you reinforce training with your pet on a regular basis. Since the tolerance level to Static Correction varies from pet to pet, Radio Systems® Corporation CANNOT guarantee that the system will in all cases keep a pet outside of the established barrier area.
Proper fit of the collar is important. A collar worn for too long or made too tight on the pet’s neck may cause skin damage. Ranging from redness to pressure ulcers; this condition is commonly known as bed sores. - Avoid leaving the collar on the pet for more than 12 hours per day. - When possible reposition the collar on the pet’s neck every 1 to 2 hours. - Check the fit to prevent excessive pressure; follow the instructions in this manual.
• To avoid damage to the Threshold Transmitter, do not use on wet surfaces, in damp or wet locations or around swimming pools. This product is designed for indoor use only. Do not expose to rain or snow. • To avoid potential damage to your Threshold Transmitter, do not stand or step on Threshold Transmitter. www.petsafe.
Thank you for choosing PetSafe® brand. You and your pet deserve a companionship that includes memorable moments and a shared understanding together. Our products provide you with the tools and technologies to successfully train your pet. If you have any questions about our products or training your pet, please visit our website at www.petsafe.net or contact our Customer Care Center at 1-800-732-2677. To get the most protection out of your warranty, please register your product within 30 days at www.petsafe.
Components Other Items You May Need • Drill • Screw Driver • Non-metallic collar and leash • Scissors • Lighter www.petsafe.
How the System Works The PetSafe® Pawz Away® Threshold Pet Barrier keeps your pet from entering or leaving a certain room, from going up or down stairs, off of furniture, etc. Just place the Threshold Transmitter near the area your pet should avoid. The Threshold Pet Barrier transmits an adjustable elliptical radio signal. Your pet wears a Receiver Collar with Contact Points that touch his neck.
Operating Guide Step 1 Placement of the Threshold Transmitter The Threshold Transmitter emits a radio signal from all sides in an elliptical pattern. The signal may transmit through a wall or the ceiling/floor. The Threshold Transmitter can be placed laying flat on a surface or mounted on a stair riser or wall. If you choose to mount the Threshold Transmitter, note that the signal becomes very directional—the signal will be strongest directly above the unit.
Step 2 Set Up the Threshold Transmitter To prevent an unintended correction, never perform set-up procedures while your pet is wearing the Receiver Collar. 1. Turn over the Threshold Transmitter and remove the battery door. Install four AAA alkaline batteries (2A) and replace the battery door. 2. Slide switch on back of Threshold Transmitter to Training Mode until your dog has learned his boundary. 2A Turning the Threshold Transmitter ON Turn the Threshold Transmitter right side up.
Step 3 Test the Barrier Area For proper operation, the Receiver Collar maximum operating height is 36 inches from the Threshold Transmitter. 3A 3B If you have more than 1 pet, set up the Threshold Pet Barrier for your tallest pet. Place the Threshold Transmitter in the desired location. If planning to mount on a stair, lean it up against the back of the stair and test for proper operation before mounting.
5. Use your pet’s height as a starting point in choosing the appropriate level to set the Threshold Transmitter (3C). Note: Should you find that you are not getting the desired range, adjust the setting, or relocate the threshold transmitter slightly. Metal objects can alter the magnetic field and change the transmitting signal range. The effect on the range depends on the size and shape of the objects.
Step 4 Fit the Receiver Collar on Your Pet Important: Proper fit and placement of your Receiver Collar is necessary for effective operation. The Contact Points must have direct contact with your pet’s skin on the underside of his neck. Proper fit of the collar is important. A collar worn for too long or made too tight on the pet’s neck may cause skin damage. Ranging from redness to pressure ulcers; this condition is commonly known as bed sores.
To assure a proper fit, please follow these steps: 1. Using the edge of the Test Light Tool, turn the battery door to the OFF position. 2. Start with your pet standing comfortably (4A). 3. Place the Receiver collar on your pet so that the PetSafe® logo is facing your pet’s chin. Center the Contact Points underneath your pet’s neck, touching the skin. If your pet has a long or thick coat then it may be necessary to trim the hair around the Contact Points to make sure that contact is consistent.
To Re-Thread the Collar The slide buckle prevents the collar from becoming loose around your pet’s neck. The ridges must be facing up; the collar will slip if it is not properly threaded. www.petsafe.
Receiver Collar Batteries The PetSafe® Pawz Away® Receiver Collar uses two 3-volt Lithium coin cell batteries, size CR2032, PetSafe® RFA-35-11. Replacement batteries can be found at many retailers or through the Customer Care Center. Contact the Customer Care Center at 1-800-732-2677 or visit our website at www.petsafe.net to locate a retailer near you. Battery life will vary depending on how often your pet tests the system and receives a Static Correction.
Additional Features Time Out Feature As a safety feature, the Receiver Collar has a built in Time Out feature. If your pet stays in the Barrier Area for longer than 13 to 15 seconds the Receiver Collar will stop delivering the Progressive Static Correction. The Receiver Collar will then administer a random single Static Correction every 4 to 10 seconds at the maximum level until the pet leaves the Barrier Area.
Training Guide The PetSafe® Pawz Away® Threshold Pet Barrier operates on the principle of positive and negative reinforcement. Your pet will learn to avoid the Barrier Areas you have set after receiving a Progressive Static Correction (negative reinforcement) and your pet will learn that he is more comfortable when he avoids the Barrier Areas (positive reinforcement). In some cases, it may not be necessary to train your pet. You can let your pet wander freely to determine the new boundaries.
Further Training If your pet is confused or unsure how to avoid the Barrier Areas then you may need to teach your pet how to do so by following these easy training steps: 1. Place a second non metallic collar on your pet ABOVE the Receiver Collar and attach a long leash. Be sure the extra collar does not put pressure on the Contact Points of the Receiver Collar. 2. Walk your pet toward the Barrier Area.
Accessories To purchase additional accessories for your PetSafe® Pawz Away® Threshold Pet Barrier, contact the Customer Care Center at 1-800-732-2677 or visit our website at www.petsafe.net to locate a retailer near you.
Troubleshooting Threshold Transmitter does not appear to work. Barrier Area range is too low. Barrier Area range is too high. Pet seems to receive no stimulation. • Press Mode button and verify Green light turns ON when button is pressed. Check that the Low Battery Indicator is not flashing Red. • Check/replace batteries in Threshold Transmitter and Receiver Collar. • Move the Receiver Collar closer to the Transmitter to test operation.
Terms of Use and Limitation of Liability 1. Terms of Use This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices. 2. Proper Use This Product is designed for use with pets where training is desired. The specific temperament of your pet may not work with this Product.
Compliance FCC/Canada This Class B digital apparatus complies with Canadian ICES-003. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment.
Customer Care International USA & Canada - Tel: 800-732-2677 Monday - Friday 8 AM - 8 PM / Saturday 9 AM – 5 PM Australia - Tel: 1800 786 608 Monday - Friday 7:30 AM - 5 PM New Zealand - Tel: 0800 543 054 Monday - Friday 10:30 AM - 7 PM Perchlorate Battery Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Warranty One Year Non-Transferrable Limited Warranty This Product has the benefit of a limited manufacturer’s warranty. Complete details of the warranty applicable to this Product and its terms can be found at www.petsafe.net. www.petsafe.
Customer Care Center 1-800-732-2677
www.petsafe.
Radio Systems® Corporation 10427 PetSafe Way Knoxville, TN 37932 1-800-732-2677 www.petsafe.net Protected by US Patents 7,046,152; 7,068,174; 7,117,822; 7,204,204; 7,278,376; 7,495,570, 8,342,135, and other patents pending.
