Owner's Manual

10 Customer Care Center 1-800-732-2677
Set Up the Barrier Transmitter
To prevent an unintended correction, never perform set-up procedures while
your pet is wearing the Receiver Collar.
1. Turn over the Barrier Transmitter and rotate
back cover counter-clockwise, removing
the back cover. Install three AAA alkaline
batteries and replace the back cover. Turn
clockwise to secure cover.
2. Turn the Barrier Transmitter right side up
and press the (+) button once to turn ON
the Barrier Transmitter. A black bar in the
upper right hand corner of the LCD display
window indicates that the Barrier Transmitter
is set to mode A* (2A). A second black bar in
the bottom of the LCD display indicates the
range is set to one segment.
2A
3. Each segment represents approximately 5 inches from the unit.
You can create a Barrier Area of 5 inches to 30 inches from the unit.
Using the (+) and (-) buttons, adjust the range to fit the desired pet
Barrier Area.
Step
2