Owner's Manual
To assure a
proper
fit, please
follow
these
steps
:
1.
Using the edge
of
the Test Light
Tool,
turn the battery
door
to
the OFF position.
2. Start with your pet standing comfortably (4A).
3. Place the Receiver collar on your pet so that the PetSafe® logo is facing
your pet's chin. Center the Contact Points underneath your pet's neck,
touching the skin. If your pet has a long
or
thick coat then it may be
necessary to trim the hair around the Contact Points
to
make sure that contact is consistent.
Note: The Receiver Collar comes with
Short
Contact Points.
Long
Contact Points are
available
and
can
be
purchased through the Customer Care Center.
4.
Adjust the tightness
of
the Receiver Collar
to
fit your
r-4---------r----....,
pet's neck. Check the tightness
of
the Receiver Collar by
inserting one finger between the end
of
a Contact Point
and your pet's neck. The fit should be snug
but not constricting
(48).
5. Allow your pet
to
wear the Receiver Collar for several
minutes then recheck the fit. Check the fit again as your
pet becomes more comfortable with the Receiver Collar.
6.
Once you
are
satisfied with the fit of the Receiver Collar
then you may trim any excess collar strap
as
follows (4C):
a.
Mark the desired length
of
the Receiver Collar with a pen.
Allow
for
growth if your pet is young
or
grows a thick
winter coat.
b. Remove the Receiver Collar from your pet and
cut off the excess.
c. Before placing the Receiver Collar back onto your pet, seal the edge
of
the
cut
collar by
applying a flame along the frayed edge.
10
1-800-732-2677