Owner's Manual
Toy
Assembly
No
assembly
is
required.
To
use,
simply install batteries, press the power button and place the Zoom on the Aoor. Do not place the toy on
any surface other than a
Aat,
level Aoor.
Battery
Installation
1.
Remove the battery
door
which
is
located on the bottom
of
the toy IA).
2. Insert 3
AA
batteries into the battery comportment
(B).
3. Replace the battery
door
and ensure it
is
closed properly.
Operating
Instructions
The Zoom Toy rotates
two
lasers
in
a
360
degree pattern for 15 minutes, then automatically powers off.
1.
Place
the
toy on the Aoor.
2.
Press
and release the
power
button
located
on the side
of
the toy
to
turn
on
power
IC)
.
3.
The
toy will activate and make one
beep
noise and the lasers will flash three times.
4.
The
toy will automatically turn
off
after 15 minutes.
5.
If you wish to end the
play
session before the toy automatically
turns
off, press the power button one time.
To
Ensure
Proper
Function
•
Do
not mix
old
and new batteries.
•
Do
not mix standard, alkaline
or
rechargeable batteries.
•
Do
not
use
rechargeable batteries.
• Exhausted batteries should
be
removed immediately. Do not dispose
of
batteries with household waste.
Advice
for
use
Apart
from ploying with
this
product, it
is
recommended that pet parents interact with their pets and provide a variety
of
ploy
activities,
opportunities for stimulation and appropriate amount
of
doily
exercise as determined
by
their veterinarian.
X
Important
Recycling Advice
- Please respect the Waste Electrical and Electronic Equipment regulations
in
your country.
This
equipment
must
be
recycled. If you no
longer require
this
equipment,
do
not
place
ii
in
the normal municipal waste system. Please return it to where it was purchased
in
order
that it con
be
placed
in
our recycling
system.
If
this
is
not possible, please contact the Customer Core Center for further information.
For
o
listing
of
Customer Core Center telephone numbers, visit our website
at
petsofe.com.
Compliance
FCC
This
device complies with port
15
of
the FCC
Rules.
Operation
is
subject to the following
two
conditions:
11)
This
device may not cause
harmful interference, and (2) this device
must
accept
any interference received, including interference that may cause undesired operation.
CAUTION: Modification
or
changes
lo
this
equipment not expressly approved
by
Radio Systems~ Corporation may void the user's
authority to operate the equipment.
NOTE:
This
equipment has been tested and found to
comply
with the limits for a Closs B digital device, pursuant to part 15
of
the FCC
Rules.
These limits ore designed to provide reasonable protection against harmful interference
in
a residential installation.
This
equipment