Owner Manual

6 Customer Care Center [phone]
Getting Started
Litter Box Setup
Your ScoopFree
®
litter box is packaged for protection during shipping. Please remove all packaging material carefully. The power adaptor is
shipped inside the packaging material. DO NOT discard the packaging until you complete the product setup.
1. Find a clean, dry and level location with a
standard power outlet nearby. Insert the barrel
end of the power adaptor into the connection
under the back of the litter box frame. Push the
cord into the slot on either side of the adaptor
connection to help keep it in place. Plug the
power adaptor into the wall outlet. After the
rake stops, the manual rake button LED light
will illuminate solid blue.
2. Install the waste trap by aligning the pegs
at the bottom of the waste trap lid with the
notches at the front of the litter box frame.
Push the waste trap lid down until it snaps fully
into place.
3. Place the lid under the litter tray. The lid is
extra protection against leaks and will be
used later for disposal.
4. Empty the crystal litter into the litter tray and
spread evenly. For best results, sprinkle one
handful of the litter under the waste trap.
5. Lift the litter box frame and place the litter
tray under it with the waste trap on the tray
below the waste trap lid on the litter box.
6. You should hear a click, which confirms
the magnets on the waste trap lid have
connected to the magnet contacts on the
litter tray. Make sure the litter box is level
and sitting over the litter tray and that the
LED light is a solid blue. If the light is blinking
blue, then something has moved in front of
the sensors and the rake cycle is counting
down from 20 minutes.
43
5 6
1
2