Owner's Manual

7
2. Mount the transmitter, using the provided mounting hardware
and the mounting template at the back of this guide. Use both
screws and anchors for installation in drywall; otherwise, use
screws only. Once the screws are in place, fit the holes on
the back of the transmitter onto the screws and then slide the
transmitter down to secure it.
3. If you purchased a PetSafe
®
Surge Protector (LP-4100-1),
follow the instructions provided with the surge protector to
install it in the electrical outlet.
Don’t plug in the transmitter or connect any wires yet; we’ll do
this in a later step.
1. Select a location for the transmitter. It must be:
• Near an electrical outlet.
• Indoors, in a dry, ventilated, and protected area, where
temperatures will not fall below -4°F/-20°C or above
104°F/40°C.
• Near a window or on a wall you can drill through, since
the boundary wire will run from the transmitter and exit the
building.
• At least 3 feet from any large metal objects or appliances,
as these items may interfere with signal consistency.
• In a location where you can hear and access the transmitter,
in case of any system alarms.
Install the transmitter
3
3 feet