Owner's Manual

15
1. Strip 3/8 inch of insulation from each end of the boundary
wire running from outside.
2. Insert the stripped ends of the boundary wire into the boundary
wire terminals on the bottom of the fence transmitter. To insert
each wire:
a. Press the red plastic tab.
b. Insert the wire into the terminal.
c. Release the tab.
There should be one wire in each terminal. Make sure the wires
do not touch each other at the terminals.
Connect the wires
6
Important: If you are using a PetSafe
®
Surge Protector (LP-4100-1), skip the steps in this section and instead follow the instructions
provided with the surge protector to connect the boundary wire to the transmitter and surge protector.
3. Plug the transmitter power adaptor into the outlet and connect it
to the transmitter.