Installation Guide

www.petsafe.net 33
The power and loop indicator
lights are off.
• Check that the power adapter is plugged into the fence transmitter.
• Check that the power adapter is plugged in properly.
• If the system is plugged into a GFCI or RCD outlet, check to see if the circuit has been
tripped. Reset the GFCI or RCD circuit if required.
• Verify that the outlet is working properly by plugging in a known working item such as
a radio.
• Try plugging the fence transmitter into another 120-volt outlet.
• If the lights still do not come on, the fence transmitter and/or power adapter needs to be
replaced. Contact the Customer Care Center.
• If a surge protector is installed, unplug the surge protector and plug the power adapter
directly into the outlet. If the transmitter operates without the surge protector, contact the
Customer Care Center for a replacement surge protector.
The power light is on, the loop
indicator light is off, and the
fence transmitter loop alarm
is sounding.
• Check the boundary wire connections at the fence transmitter for proper connection.
• Check for broken or damaged boundary wires at the outside entry to the house.
• Perform the “System Test” (page 29) to determine if the fence transmitter or surge protector
needs to be replaced.
• If the fence transmitter is functioning properly, you have a break in your boundary wire. See
the “Wire Break Location Test” section (page 30) in this guide.
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and notices contained herein.
Usage of this Product implies acceptance of all such terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific temperament of your pet may not work with this Product. If
you are unsure whether this is appropriate for your pet, please consult your veterinarian or certified trainer.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm, injure or provoke. Using this Product in a way
that is not intended could result in violation of Federal, State or local laws.
4. Limitation of Liability
In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive, incidental, special or consequential damages, or any
damages whatsoever arising out of or connected with the use or misuse of this Product. Buyer assumes all risks and liability from the use of
this Product.
5. Modification of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices under which this Product is offered.