Owner's Manual

[phone]
• Proper training of your pet is essential to successfully using the system. During the first 2
weeks of training, do not use the system without direct supervision of your pet.
• The receiver collar should not be on your pet when the system is tested. If it is, your pet
may receive an unintended correction.
• Do not change the transmitter setting from Traditional mode (B) to YardMax
®
mode (A)
without verifying that the receiver collar will still contain your pet.
• If the receiver collar fails the ReadyTest
®
startup, the receiver collar is automatically
turned off. Your pet will not be contained.
• Always remove your pet’s receiver collar before performing any fence transmitter
testing. This will prevent unintended corrections.
• The boundary width of the system must be tested whenever an adjustment is made to the
pet area to prevent unintended corrections to your pet.
• To prevent an unintended correction, after the boundary flags have been placed, be
sure to set the static correction on the receiver collar back to level 1, which is tone only.
• Remove the receiver collar from your pet when indoors for the comfort of your pet.
• You should expect hundreds of recharge cycles from your battery; however, do not
charge your receiver collar every night. Charging too often can reduce battery life.
• Charge your receiver collar when the receiver indicator light blinks red.