Owner's Manual
Table Of Contents
- Product Manual
- Welcome
- Important Safety Information
- How the System Works
- Charge the Receiver Collar
- Prepare the Receiver Collar
- Fit the Receiver Collar
- Taking Your Pet Out of the Pet Area
- Advanced Features
- Over Correction Protection
- Receiver Collar Status Indicators
- Troubleshooting
- Terms of Use and Limitation of Liability
- Compliance
- Battery Disposal
- Warranty
petsafe.com 25
Troubleshooting
The receiver collar
is not beeping
or correcting.
• Make sure the receiver collar is turned on,
and the battery status lights are flashing every
4 seconds.
• Charge the receiver collar and go through
the ReadyTest
®
startup and PerfectFit
diagnostic tests.
• Check that the fence transmitter power is turned
on and the transmitter status light is solid green.
If not, refer to the YardMax
®
Rechargeable
In-Ground Fence
™
manual.
• In YardMax mode (A), excessive snowfall
(>1½ ft.) may place your pet outside the signal
field. You may need to switch to Traditional
mode (B) or increase the boundary width until
the snow recedes.