Full Product Manual

6 1-800-732-2677
How the System Works
A radio signal travels from the Fence Transmitter through a buried wire, marking the boundaries you wish to set for your dog.
Your dog wears a Receiver Collar that detects the signal at the boundary. As your dog approaches the boundary, the receiver
issues a warning tone and vibrates. If he proceeds further, he receives a safe but startling Static Correction. While harmless,
the correction will persuade him to stay in the containment area you’ve established. Boundary flags are a temporary visual
aid for your pet; remove them after training. This PetSafe
®
Stubborn Dog In-Ground Fence
™
System has been proven safe,
comfortable, and effective for pets over 8 pounds.
Key Definitions
Fence Transmitter: Transmits the radio signal through the Boundary Wire.
Pet Area: Area within the Warning Zone where your pet can roam freely.
Warning Zone: Outer edge of the Pet Area where your pet’s Receiver Collar begins to
beep and vibrates for 2 seconds, warning him not to go into the Static Correction Zone.
Static Correction Zone: Zone beyond the Warning Zone where your pet’s Receiver
Collar will emit a Static Correction, signaling him to return to the Pet Area.
Boundary Width: Combination of the Warning Zone and the Static Correction Zone.
Surge Protector: Installed with the Fence Transmitter to protect it from lightning
strikes and power surges (USA and Canada only).
Receiver Collar: Receives the radio signal from the Boundary Wire.
Correction Level Button: Adjusts the level of Static Correction your pet receives in
the Static Correction Zone.
Receiver Indicator Light: Indicates the level of correction at which the Receiver
Collar is set. This light also serves as a low battery indicator.
Contact Points: Delivers the safe Static Correction when your pet moves into the
Static Correction Zone.
Power Jack: Where the Power Adapter plugs into the Fence Transmitter.
Boundary Control Switch: Switch located on the
Fence Transmitter to adjust according to the length of
Boundary Wire used.
Boundary Wire Terminals: Where the Boundary Wires
connect to the Fence Transmitter in order to complete a
continuous loop.
Loop Indicator Light: Indicates that the Boundary Wire
makes a complete loop, enabling the signal
to be transmitted.
Boundary Width Control: Adjusts the width of the
Warning and Static Correction Zones. Note: Adjusting
the knob does not change the level of Static Correction
on the Receiver Collar.
Correction
Level
Button
Contact Points
Washers
Receiver Collar
Boundary Control Switch
Boundary Wire
Terminals
Loop Indicator Light
Power Light
Power
Jack
Boundary Width
Control
Fence Transmitter
Pet
Area
Static Correction
Zone
Static Correction
Zone
Surge
Protector
with Power
Adapter
Fence
Transmitter
Warning
Zone
Warning
Zone
Boundary
Width