Owner's Manual
Table Of Contents
Test Light Instructions
1.
Make sure the Receiver Collar battery is properly installed.
2.
Set the Correction Level
to
2 or above.
3.
Hold the Test Light Contacts
to
the Contact Points
(1
F).
4.
Walk toward the Boundary Zone holding the Receiver collar
at
your
pet's neck level
(1G) until the Test Light flashes
(1
H).
Save Test Light for future testing.
Note: If the Test Light does not flash, check the battery status
by
turning the receiver off, then on and verify the light is green. If the light
is red install a new battery and re-test. If Test Light still does not flash,
contact the Customer Care Center at 1-800-732-2677.
1H
20
1-800-732-2677