Instructions / Assembly
1-800-732-267 718
Test Light Instructions
1. Make sure the Receiver Collar battery is properly installed.
2. Set the Correction Level to 2 or above.
3. Hold the Test Light Contacts to the Contact Points (1F).
4. Walk toward the Boundary Zone holding the Receiver collar at your
pet’s neck level (1G) until the Test Light flashes (1H).
Save Test Light for future testing.
Note: If the Test Light does not flash, check the battery status by turning
the receiver off, then on and verify the light is green. If the light is red
install a new battery and re-test. If Test Light still does not flash, contact
the Customer Care Center at 1-800-732-2677.
Pet
Area
B
o
u
n
d
a
r
y
Z
o
n
e
1F 1G 1H