Installation Guide

32 1-800-732-2677 www.petsafe.net 33
Troubleshooting
The Receiver Collar
is not beeping
when setting up
the Boundary Zone.
•Make sure Receiver Collar is turned on and
Battery Status Lights are flashing every 4-5
seconds
•Charge Receiver Collar
•The beep may be difficult to hear in a noisy
environment.
•Use Test Light as explained in the “Test
Light Instructions” section, and use it to
determine the location of Boundary Zone.
•Check that the Transmitter is set up
according to directions.
The Receiver Collar
is not beeping or
administering a
Static Correction.
•Make sure Receiver Collar is turned on and
Battery Status Lights are flashing every 4-5
seconds
•Charge Receiver Collar
•Check that the Transmitter is plugged into a
working 120-volt outlet, the Power Light is
on, and the Transmitter controls are set at
your desired settings.