Owner's Manual

9
www.petsafe.net
Charge the Receiver Collar
Lift and slide the Receiver Collar strap away from the front of the unit (2A). Lift the rubber plug to allow access to the
Receiver Charge Jack. The rubber plug needs to remain attached to the Receiver Collar. Plug the Receiver Charger into
the Receiver Charge Jack on the Receiver Collar. The Receiver Charge Jack and Receiver Charger are keyed to fit one
way. Do not force it in backwards.
Step 3: Prepare the Receiver Collar
Your Receiver Collar comes with Short Contact Points. Use the Long Contact Points for pets with long or thick hair.
Tighten the Contact Points using the Contact Point Wrench (3A). Check tightness weekly.
Turn the Receiver Collar ON
Press and hold the Mode Button continuously for 5 seconds (3B). The green or yellow or red Receiver Indicator Light
will turn ON for 5 seconds (3C) to indicate battery status, followed by the red Receiver Indicator Light flashing the
Static Correction level settings.
Turn the Receiver Collar OFF
Press and hold the Mode Button continuously for 5 seconds. The red Receiver Indicator Light will be ON during this time.
The red Receiver Indicator Light will then turn OFF and all Receiver Indicator Lights will stay OFF indicating that the unit is
turned OFF.
To extend the time between charging the Receiver Collar, consider turning OFF the Receiver Collar when it is not in use.
2A
3A
Mode
Button
3B 3C