Owner's Manual

12
1-800-732-2677
Step 4: Adjust the Pet Area to Desired Size
Make sure the entire Pet Area lies within your property boundaries (4A). Always start determining the Boundary Zone
at the shortest distance from Transmitter. Place the Boundary Switch on “Low” if the Boundary Zone will be less than 45
feet from the Transmitter.
Test Light Instructions
1. Make sure the Receiver Collar Battery is properly charged. Set the Correction Level to 2 or above.
2. Hold the Test Light Contacts to the Contact Points. (4B)
3. Walk toward the Boundary Zone holding the Receiver Collar at your pet’s neck level
( 4E ) until the Test Light
flashes (
4F ).
Save Test Light for future testing.
Note: If your next-door neighbor has an In-Ground Containment System, see Troubleshooting section page 23.
To maximize your Pet Area, make sure the Boundary Switch is on “High”
( 4C ) and the Boundary Control Dial
is set to “8” (4D). Plug the Power Adapter into the Power Jack and a standard 120 volt outlet.
Two-Person Method
Hold the Receiver Collar at your pet’s neck height ( 4E ) with logo side facing away from the Transmitter and Contact
Points facing upwards. Walk to the edge of the desired Pet Area. Facing away from the Transmitter, hold the Receiver
Collar at the edge of the desired Pet Area (
4F ).
Starting with the Boundary Control Dial set to “8”, have a second person turn the dial down SLOWLY. When the
Receiver Collar tone starts, tell the person to stop turning the Boundary Control Dial. Walk back into the Pet Area until
the receiver stops sounding. Verify the Pet Area boundary by walking towards the Boundary Zone and verifying that the
tone/test light flashes begin at the desired location. Test at multiple locations around the Pet Area to verify the Pet Area
is within your desired location. Record your settings on page 13 for future reference.
Pet Area
Street
4A 4B
LOW
HIGH
4C
4E
8
7
4D
Pet
Area
B
o
u
n
d
a
r
y
Z
o
n
e
4F