Owner's Manual

11
www.petsafe.net
Set the Static Correction Level
Read all steps before attempting to set the Static Correction Level.
1. Press the Mode Button and release (3B) when the Receiver Indicator Light illuminates Red (3C).
2. The Receiver Indicator Light will emit a series of Red flashes representing the Static Correction Level.
3. Increase the Static Correction Level by pressing and releasing the Mode Button within 5 seconds of the previous
series of flashes.
The Static Correction Levels increase in strength from 1 to 6. Pushing the Correction Level Button while the Receiver
Collar is on Level 6 will cause the Receiver Collar to revert to Level 1. Refer to the Function and Response Table to
choose the Static Correction Level that best fits your pet.
Function and Response Table
Indicator Light
Response
Static
Correction
Level
Receiver Collar Function
Temperament
of Pet
1 Red Flash 1 No Static Correction, Tone Only Initial Training Mode
2 Red Flashes 2 Low Static Correction Timid
3 Red Flashes 3 Medium-Low Static Correction Timid or Average
4 Red Flashes 4 Medium Static Correction Average Energy
5 Red Flashes 5 Medium-High Static Correction Average or High Energy
6 Red Flashes 6 High Static Correction High Energy
Over Correction Protection
If your pet enters the Boundary Zone or continues anywhere beyond the Pet Area, this feature limits the Static
Correction duration to 15 seconds. While the system locks out further Static Correction, the green light will remain on
for 10 seconds.
In the unlikely event that your pet leaves the Pet Area, he will not receive a Static Correction upon return to the Pet Area.