Owner's Manual

14 Customer Care Center 1-800-732-2677
3. Press RIGHT button to move to the hour eld to set the time for meal 1.
4. Use UP or DOWN buttons to set hour for meal 1. If in 12 hour time format, set hour
with desired AM or PM setting. Press RIGHT button to move to minute eld.
5. Use UP or DOWN buttons to set minute. Each meal time can be set in 15 minute
increments. Press RIGHT button to move to meal size eld.
6. Use UP or DOWN buttons to set desired meal size. Meal size can be adjusted in
1/8-cup (30 ml) increments, with a minimum portion of 1/8-cup (30 ml) to maximum
portion of 4-cups (946 ml).
7. Press RIGHT button to move back to meal number
eld. Use UP button to move to next meal, which is
meal 2. The LCD screen should show time of 5:00 PM
(17:00 if in 24 hour format) and meal size of 2 cup,
unless a different meal was previously setup. To
schedule a second meal, press RIGHT button to
move to hour eld to set time. Repeat steps 4 through 7 for as many meals (up to 12)
you want to schedule.
Note:
Up to 12 meals can be scheduled. For any of the 12 meal options you do
not want to schedule, leave the meal size fields blank or set to “--- cup” or “--- ml”.
8. After programming desired number of meals, return to the meal number eld. Press and
HOLD ENTER button for 5 seconds to program feeding schedule and enter Operating
Mode (see “Operating Mode” page 15 for more details). The LCD screen will then
display the time and size of next scheduled meal.
2C.
Fill With Food:
Do NOT use outdoors. FOR INDOOR HOUSEHOLD USE ONLY.
Check operation frequently to be sure the pet feeder is dispensing
properly. For dry food use only. DO NOT use wet, canned or moist
food. Pet feeder should be placed on a level surface.
Do not install or store pet feeder where it will be exposed to weather or
temperatures below 40° F.
Place feeder in desired location. Fill feeder hopper with dry or semi-moist pet food,
allowing room to replace lid.
To Replace Lid: Align front tab on lid into slot behind
the control panel. Lower back of lid and push down
until lid latch snaps into place.
To Prepare Conveyor with Food: If buttons are
locked, press ENTER and UP buttons AT SAME
TIME to unlock. Next press ENTER and LEFT
buttons AT SAME TIME to prepare feeder conveyor
to dispense food. Release buttons when you hear
conveyor moving and lling each section with food
getting ready for the rst scheduled meal. Pieces
of food may be dispensed into the bowl. Pour any
dispensed food back into hopper. Every time the
hopper is empty or almost empty and is relled with food, the conveyor must be prepared.
Note:
If conveyor is not prepared as instructed, no meal or incorrect meal sizes
will be dispensed. Ensure conveyor is properly prepared with food every
time hopper is refilled.
Example Meal: