Owner's Manual

12 Customer Care Center 1-800-732-2677
To Install Hopper:
Align back food
chute on hopper
over conveyor
agitator. Ensure
conveyor agitator is
inside back chute
and lower hopper
into base. Gently
push hopper until
release button
snaps into place.
Note:
If hopper
is not installed
correctly with agitator inside back food chute, agitator can break. Also incorrect meal
sizes or no food at all will be dispensed.
To Install Bowl:
Slide tabs on bowl
holder into slots on
front of feeder until
tabs lock into place.
Insert bowl into
holder by placing
back of bowl under
food chute and
tilting front of bowl
forward, sliding
under lip on holder.
Lower back of bowl
into place.
Initial Setup
2A. Time Setup:
The feeder automatically enters into Setup Mode after batteries are installed or power is
connected. The LCD will show a blinking 12 to set time format.
Note:
If time is set to 12 hour format, meal size measurement is automatically set to
cups. If time is set to 24 hour format, meal size measurement is automatically set to
milliliters.
To Set Time:
1. After powering feeder, the LCD will show a blinking
12 for time format setup. Use UP or DOWN buttons
to scroll to select 12 hour or 24 hour time format.
Press RIGHT button to set time.
12 Hour Format:
1. For 12 hour format, the screen will show 12:00 AM
with the hour eld blinking. Use UP or DOWN
buttons to scroll through numbers to set current
hour with current AM or PM. Press RIGHT button to
move to minute eld.
Step 2