Owner's manual

FieldPro Owner’s Manual
7
Step 2 Turning the Receiver ON and OFF
11..
Put the threaded end of the Antenna
into the Transmitter and turn until
finger-tight.
22..
Hold the Receiver one inch away
from the Transmitter —
ddoo nnoott ttoouucchh
tthhee RReecceeiivveerr’’ss ccoonnttaaccttss —— yyoouu
mmiigghhtt ccaauussee sseellff--tteesstt ttoo ffaaiill
.
33..
Press and hold the Tone button. The
Receiver’s light will turn on and show
the level of battery charge (solid
green, amber, or red). Release the
Tone button.
44..
To turn Receiver OFF, hold Receiver
and Transmitter one inch apart.
Press and hold the Tone button. The
Receiver will emit a shut-down tone
sequence, and the light will glow
solid red, then go out. Release the
Tone button.
NNOOTTEE
for
TTwwoo CCoollllaarr UUssee::
Set the Transmitter
to Dog 2 and repeat steps 2 and 3 using the
second collar.
Cinch the collar around your dog’s neck to find the proper
fit. The collar fit should be snug, yet loose enough to allow
one finger to fit between the strap and the dog’s neck. Fit
is important because a loose collar may cause
inconsistent performance.
Step 3 Fit the Collar on Your Dog
11 iinncchh
22
33
Press
Step 4 Begin Training
Use the buttons on the Scout keypad to train your dog. The buttons are
discussed in detail later in this manual.
SCOUT
™
Quick Start Guide
11
The ON/OFF command only works when the Transmitter
and Receiver are in close proximity; it will not work at a
distance. The ON/OFF command only works when the
Transmitter antenna is installed.
Never turn the unit ON or OFF while your dog is wearing
the receiver collar.
SCOUT
™
Quick Start Guide