User Manual

Throughout this manual, items in a bordered box apply to
GGSS--77000000 OONNLLYY
.
Cabela’s
®
Gun Dog
®
— Owner’s Manual
4
Put the collar around your dog’s neck and adjust to find the
proper fit. Fasten the collar so the fit is snug, yet loose enough
to allow one finger to fit between the strap and the dog’s neck.
Fit is important because a loose collar may cause inconsistent
performance.
Step 3 Fit the Collar on Your Dog
11 iinncchh
22
33
Press
Step 4 Begin Training
Watch the included training DVD and read the information in the Training section on
page 14. Your dog may show good initial response to the training; be sure to follow
the training procedure for several weeks. The convenience that your new remote
training system offers is well worth the time invested.
Quick Start Guide
Step 2 Turning the Receiver ON and OFF
11
The ON/OFF command only works when the
Transmitter and Receiver are in close proximity;
it will not work at a distance. The ON/OFF
command only works when the Transmitter
antenna is installed.
Never turn the unit ON or OFF while your dog is
wearing the receiver collar.
11..
Put the threaded end of the Antenna
into the Transmitter and turn until
finger-tight.
22..
Hold the Receiver one inch away
from the Transmitter, be careful —
ddoo nnoott ttoouucchh tthhee RReecceeiivveerr’’ss
ccoonnttaaccttss;; tthhee sseellff tteesstt mmaayy ffaaiill
.
33..
Press and hold the Tone button.
The Receiver emits a start-up tone
and its light turns on showing the
level of battery charge (solid green,
amber, or red). Release the Tone
button.
44..
To turn Receiver OFF, hold Receiver
and Transmitter one inch apart and
press and hold the Tone button. The
Receiver will emit a shut-down tone
sequence, and the light will glow
solid red, then go out. Release the
Tone button.
NNOOTTEE
for
TTwwoo CCoollllaarr UUssee::
Set the Transmitter
to Dog 2 and repeat steps 2 and 3 using the
second collar
.
Quick Start Guide