Installation Guide

www.petsafe.net 25
Days 15 thru 30 - Pet Monitoring
Your pet is ready to run! Check in on your pet at regular intervals.
Note: After you are satisfied your pet’s training is complete, remove every other Boundary
Flag every 4 days until all flags are removed. Save Boundary Flags for future use.
Taking Your Pet Out of the Pet Area
Important: Remove the Receiver Collar and leave it in the Pet Area.
Once your pet learns the Boundary Zone, he will be reluctant
to cross it for walks or car rides.
Option 1: Replace the Receiver Collar with a regular collar.
Put your pet in a car that is within the Pet Area and drive him
out of the Pet Area.
Option 2: Replace the Receiver Collar with a regular collar
and leash. Walk your pet out of the Pet Area while giving a
command such as “OK” at a specific place of the Boundary
Zone (the end of your driveway, sidewalk, etc.). Always
leave the Pet Area with a leash at this place and your pet
will associate leaving the Pet Area only on a leash, only at
this place, and only with a person. You may initially need to
convince your pet to leave the Pet Area with a food treat and
lots of praise.
Note: You may also carry your pet out of the Pet Area.
Congratulations! You have now successfully
completed the training program.
Accessories
To purchase additional accessories for your PetSafe
®
Basic In-Ground Fence
™
, contact
the Customer Care Center at 1-800-732-2677 or visit our website at www.petsafe.net to
locate a retailer near you.
Component Part Number
Battery - two pack RFA-67D-11
Power Adapter for the Fence Transmitter* RFA-14
Surge Protection Kit* LP-4100-1
Replacement Collar* RFA-41-1
Additional Receiver Collar HIG11-13658
Stubborn Dog Receiver Collar RF-275-11
Additional Boundary Wire* RFA-1
Additional Boundary Flags* RFA-2
Wire & Flag Accessory Kit PRFA-500
Fence Transmitter* 300-678
Wire Break Locator* RFA-450
*Only available through the Customer Care Center.
Phase
5