Instructions / Assembly

14 1-800-732-2677

Function and Response Table

Indicator Light

Response

Static Correction

Level

Receiver Collar Function Temperament of Pet

1 Flash 1 No Static Correction, Tone Plus Vibration Initial Training Mode

2 Flashes 2 Low Static Correction Timid

3 Flashes 3 Medium Static Correction Timid or Average

4 Flashes 4 Medium High Static Correction Average or High Energy

5 Flashes 5 High Static Correction High Energy

Flashes once every

4 to 5 seconds

Indicates Low Battery

Set the Boundary Width and Test the Receiver Collar

With the Boundary Wire in place and properly connected, it is time to set the containment

ﬁeld and test the system.

CAUTION

The Receiver Collar should NOT be on your dog when the system is tested.

Note: The Receiver Collar is waterproof, which can make the tone hard to hear.

The ﬂashing Test Light when held to the Contact Points indicates the Receiver Collar is

delivering Static Correction. To best utilize the automatic Run-Through Prevention feature,

the containment Boundary Width should extend at least 6 to 10 feet on each side of the

Boundary Wire (total Boundary Width of 12 to 20 feet).

1. Apply Power to the Fence Transmitter with the supplied Power Adapter.

2. Set the Boundary Width Control Switch (located on the side of the

Fence Transmitter)

(6A)

to the A, B, or C setting based on the total

length of Boundary Wire used.

Setting B is used for most properties.

The

table to the right will indicate the proper setting.

3. The width of the containment ﬁeld is adjusted using the transmitter’s

Amount of Wire Setting

Greater than 2400 feet A

Up to 1300 feet B

1300 to 2400 feet C

Boundary Width Control knob. Turn the knob counterclockwise until the alarm sounds and the Loop

Indicator Light is no longer lit. Turn the knob clockwise and increase by 2 numbers. The alarm should turn

OFF and the Loop Indicator Light should turn ON.

CAUTION

The Receiver Collar should not be on your dog when the system is tested. Your pet may receive an unintended correction.

4. Place battery in Receiver Collar. To identify the Warning and Static Correction Zones make sure the

Receiver Collar is set at level 5 (see Step 5).

Step