Owner's manual

www.petsafe.net

As with any electrical device, check the electrical

cord for any tears or damage before use.

Inspect the bottom of the fountain to be sure the

motor is securely attached. (Fig. 1)

Remove the housing lid and insert the charcoal

lter. The lter will t diagonally into the two

triangular slots located inside the housing. The

lter ts narrow side down, with the black side

facing the front of the fountain (toward the spout).

The lter will slide easily into place, but make sure

it is pushed all the way down. (See Fig. 2a & 2b)

DO NOT RUN DRY - FOR INDOOR USE ONLY

OPERATING INSTRUCTIONS

MOTOR

Fig. 1

Fig. 2a

Fig. 2b

FILTER

NOTE: Rinse the lter thoroughly under cool water before placing

in the fountain. This will remove any loose charcoal dust, which is

harmless. A small amount of charcoal dust may shed for the life of the

lter. This is normal and not harmful to your pet.

Place fountain in desired location. If placing on carpet, tile or

wood ooring use a protective mat or other durable, water

resistant surface to protect your oors from splashing or

dripping caused by the pet.

Fill the unit with water. This includes both the bowl and the

lter housing. This will prime the pump. Replace the lid.

Before you plug the fountain in, make sure the cord and your

hands are dry. Plug the fountain into an electrical outlet.