Deluxe Remote Trainer Owners Manual
INSTRUCTION MANUAL Thank you for purchasing your Deluxe Remote Trainer, one of the finest training systems available for training your dog. Due to the similarities between the Big and Little dog receivers, both are discussed in this manual. Two simple steps will prepare your unit for use. Step I – Insert the batteries in the handheld transmitter and receiver collar. Step II – Activate the receiver collar. Please remember to fill out your warranty card before continuing.
Step I — Insert Batteries Receiver for the PDLDT-305 Little Dog Trainer • Use a small Philips screwdriver to remove the two screws on the receiver. • Press the battery door up in the direction of the arrows on the door. It will move up slightly and the door will release. • Insert two, 3-volt lithium CR2032 batteries per the diagram on the receiver. • Check to ensure the gasket is in place and clean. • Replace the battery door. • Tighten the screws. Do not over tighten.
Push button (on/off) switch Step II — Activate the Receiver Collar • To activate the receiver collar, press and release the receiver’s on/off button. • When the button is pressed, the LED will immediately come on and then flash twice after the button is released, indicating that the receiver is ready to receive signals. • To turn off the receiver collar, press and release the on/off button.
USING YOUR TRAINING SYSTEM Fitting your Receiver Collar • Wash both your dog’s neck and the contact points on the receiver collar. • Place the activated receiver high on the underside of your dog’s neck. • Buckle the collar snugly on your dog, allowing enough room so that you can comfortably place one finger between the contact points and your dog’s neck. Attention: To ensure comfort, safety, and effectiveness of product please ensure the following.
Your unit comes equipped with two sets of contact points, medium and long. The medium should be used with dogs having shorter hair; the long should be used with dogs having longer hair. The contact points on the receiver, from the factory, are medium length. • Select level 1 (lowest) on your transmitter. • Walk around and wait for your dog to become distracted. button down for 2 or 3 seconds.
Your transmitter should provide you with approximately two to four months of training time. These times may vary depending upon type and frequency of used. Q #4: How will I know if a battery needs replacing? A: The LED lights on your transmitter and receiver will tell you when you have a low battery. When the batteries are low on either unit, its LED light will flash once every four seconds. Q #5: How should I store the transmitter and receiver when I am not using them? A.
Problem: The receiver collar is not delivering stimulation. 1. Check to see if the receiver is turned on. 2. Check if the receiver beeps when the tone button is pressed. 3. Use the test light to verify whether the unit is operational. PRODUCT WARRANTY Please register your product by mailing in the warranty card or registering online at www.petsafe.net. All parts are covered under warranty for the life of the product. Labor is covered for the first year of ownership.
