Manual

19
www.petsafe.net
EN
ES
PT
To Test the Bark
Control Collar
Slide the Sensor Probe across a rough surface for at least
254 mm. The Indicator of the Bark Control Collar should ash
several times. If your Bark Control Collar does not ash during
this test, see “The Bark Control Collar does not ash” in the
“Troubleshooting” section, and continue with the second step.
To Discharge the
Bark Control Collar
Important: Avoid touching the Contact Points and Sensor
Probe unless the Bark Control Collar is completely discharged.
After battery removal, the Bark Control Collar retains some
stored energy and may activate 2 or 3 additional times. To
completely discharge the Bark Control Collar, slide the Sensor
Probe across a table or hard surface several times, until the
Bark Control Collar stops ashing.