Owner Manual

www.petsafe.net
9
PET FOUNTAIN: Clean the fountain once a week.
1. Unplug the fountain and disconnect the in-line
plug (Fi g. 11).
2. Carefully lift the tower and allow the water to
slowly pour back into the bowl. Once all the
water has been emptied into the bowl, set the
tower aside for cleaning (Fig. 12).
3. Take the tower and turn upside down to remove
the rubber grommet. Grab the rubber grommet
from inside and pull straight out, set aside for
cleaning (Fig. 13).
4. Remove the filter housing from the pump by lifting
straight up (Fig. 14).
5. Open the filter housing and remove the carbon
filter from inside and dispose. Set the lid and
base of the filter housing aside for cleaning.
6. Remove the rubber cap affixed to the raised post
by inserting a finger under the lip and pull
straight up to remove (Fig. 15).
7. While securely holding the electrical power cord
and the bottom of the bowl with both hands, pour
out the remaining water inside the bowl into a sink.
8. With the in-line plug disconnected and water
removed, grab the pump and lift straight up to
disengage the suction cups. Continue pulling the
pump’s electrical power cord up and out through
the raised post in the center of the bowl. Once
the pump is completely removed from the bowl,
separate the foam filter and set aside for proper
cleaning.
9. Once the fountain is completely disassembled,
you will have: the bowl, tower, two rubber pieces,
the filter housing, foam filter and the pump.
10. Rinse the foam filter with water only or replace it
with a new one.
11. See the “Pump Maintenance” section of this
Operating Guide for detailed instructions on how
to properly clean your pump. DO NOT PLACE
PUMP IN DISHWASHER!
12. Hand wash all other fountain parts with warm
water and soap. Be sure to rinse thoroughly
with fresh water. You can also put the fountain
in the top rack of the dishwasher. If possible, it is
recommended that you turn down the heat of the
water inside the dishwasher.
Fig . 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15