Owner Manual

www.petsafe.net
7
6. Remove the extra slack from the electrical power
cord and insert the rubber cap into the raised
post. Make sure the cord channel on the rubber
cap is aligned with the electrical power cord,
then insert your finger into the rubber cap and
push all the way down (Fig. 5).
7. Fold the top of the rubber cap over the raised
post to seal off the bowl (Fig. 6).
8. Rinse the carbon filter thoroughly under cool
water before placing it into the filter housing.
This will remove any loose carbon dust, which is
harmless. A small amount of carbon dust may be
released for the life of the filter. This is normal and
is not harmful to your pet.
9. Detach the lid from the base of the filter housing.
Once rinsed off, place the carbon filter inside the
base of the filter housing with the larger side of
the filter facing down. The filter will only fit inside
the base of the filter housing one way. If it does
not fit, flip it over (Fig. 7).
10. Attach the lid to the base of the filter housing.
Press down until you hear it snap in place.
11. Attach the filter
housing to the
pump by inserting
the round notch
under the base
into the circular
opening on top of
the pump (Fig. 8).
The opening on
top of the filter housing should be right next to
the sealed raised post (Fig. 9).
12. Place the ceramic tower inside the bowl. The
rubber grommet will create a seal between the
filter housing and the tower. Carefully lower the
tower until it rests flat (Fig. 10).
Fig. 5
Fig. 6
Fig. 7
Fig. 9
Fig. 10
Fig. 8