Owner Manual

Customer Care Center 1-800-732-2677
6
OPERATING GUIDE
Assemble Fountain
• Do not use outdoors. Do not run dry. For indoor household
use only.
• Do not pull on the electrical power cord to remove the plug
from the electrical outlet.
• To unplug, grasp the plug, not the electrical power cord.
Note:
Rinse all fountain parts with warm water before operating the pet
fountain. This will remove any dust or residue that remain in the system from the
manufacturing process.
1. Carefully remove all the fountain components
from the packaging and set aside prior to
assembly.
2. As with any electrical device, check the electrical
power cord for any tears or damage before use.
3. Place the foam filter around the pump by inserting
the pump into the foam filter from the top. Make
sure the electrical power cord rests on top of the
foam filter (Fig.1).
4. Take the bowl
and place the
pump inside the
square indention.
(Fig. 2) With the
bowl positioned
so the raised post
is to the right of
the square, make
sure the pump is
positioned so that
the pump outflow, the circular opening on the top
of the pump, is positioned in the bottom left
corner of the square (Fig. 3).
5. Press down on the pump to engage the suction
cups. Once the pump is securely in place, feed
the in-line plug of the electrical power cord over
and through the raised post and out the notch
on the base of the bowl (Fig. 4). There are four
notches to choose from.
Step 1
Fig. 1
Fig. 2 Fig. 3
Fig. 4