User's Manual

If you are not using the Force paired with a device with myStigma® app installed, it is recommended

to keep the BLE setting off due to power consumption.

WARNING MESSAGES

BATTERY LOW. : The battery is empty and the motor can’t start.

OVER POWER PROTECT. : This warning pops up whenever the current running through

the device exceeds a certain amount of power. It also cuts off the power to the motor

to avoid causing damage or implications to both the machine and the power pack.

You can try the following to reset the warning:

1. First, remove the cartridge. (if any)

2. Then shut down and remove the power pack.

3. Turn it back on and attach it to the machine.

4. Press the ON/OFF button once to start the motor.

5. If everything’s alright then stop, put the cartridge back inside and run it again.

If the motor cannot run even without a cartridge needle, then stop using it and contact our customer

support to avoid further damage on the device.

Footswitch Low Battery Recharge. : The footswitch is low on battery.

Error! Use one Foot SW only. : If there are more than 1 Footswitch in close distance, try

moving further away before pairing.

SLEEP MODE

The display goes to sleep after 45 sec. Press any button to activate it again.

If the Force stays idle for more than 10 minutes it will go to sleep and after 3 hours it will

switch itself off automatically. If the battery is low, it will turn itself off after 20 seconds.

When the battery is fully charged the device again follows the above procedure.

RCA PLUG

An RCA Plug (RCA adapter) is included with every FORCE. This allows the user to work

with their machine while the Power Pack is charging or if you simply want to use cables.

Note that when using the RCA Plug the machine gets lighter and smaller but loses all smart functions like

Presets, Motion Control, Digital Give & Boost etc.

MAINTAINANCE

The Force is pre-lubricated when you receive it and does not require any lubrication.

Do not use any type of oil for lubrication.

Never spray down the machine and always try to prevent external fluids and/or other

elements from entering the machine’s mechanism as they can disrupt the smooth

operation of the machine.