User Manual

Parking Pawl Manual Release
1. Manual Release Nut
Located at the midpoint, driver's side of the
transmission.
1. Remove nut and washer at Parking
Pawl Release (1).
2. Attach Manual Release Lever and
tighten nut (only two threads) (max
torque – 7 lb∙ft (9.5 N∙m)).
3. Turn lever clockwise until lever hits
stopping surface (maximum
actuation torque – 11.8 lb∙ft (16
N∙m)).
4. Reapply nut and washer then
tighten nut.
Until the manual release lever is
repositioned to allow the Parking Pawl to
engage, Park mode will not be available.
Snow/Ice Operation
This transmission is designed to work in
coordination with the ATC system to
ensure optimal operation. However, if the
driver observes low friction road conditions
(such as snow, rain, ice) and does not want
the transmission to shift, risking wheel
slippage, the driver should select Manual
mode. Manual mode holds the current gear
position under most operating conditions-
the transmission will only shift when the
driver uses the up/downshift request. Once
road conditions improve, the driver should
revert back to Drive mode.
Start-Up and Power Down
Starting the Engine
The information provided in this topic is
intended to enhance or amend the engine
start-up procedure located in the engine
operator's and chassis operator's manuals
specific for your vehicle. Familiarize
yourself with the information in this topic,
and then make the appropriate
adjustments to those procedures, if
necessary, when starting the engine.
If Anti-Theft is enabled, the first time you
turn the ignition switch to START, you will
need to enter the Passcode.
• When instructed to set the
transmission mode (shift lever) to
Neutral (N), if your vehicle has a
Park setting, Park (P) must be
selected.
OPERATION - Snow/Ice Operation
Y53-1331 (6/21) 25
4