operators_manual
Table Of Contents
- Engine Operation
- Safety - Introduction
- Emergency - What To Do If
- Operating Instructions
- Engine Warning Lamps
- Stop Engine Lamp
- Engine, Check Engine
- Malfunction Indicator Lamp
- Diesel Particulate Filter (DPF) Warning Lamp
- High Exhaust System Temperature (HEST) Warning Lamp
- Diesel Exhaust Fluid (DEF) Lamp
- Engine Wait-To-Start Lamp
- Engine Braking System
- Driving
- Normal Starting Procedure
- Cold Weather Starting
- Starting Procedure After Extended Shutdown or Oil Change
- Operating the Engine
- Engine Operating Range
- Extended Idling
- Engine Shutdown
- Electromagnetic Interference
- Operating on Level and Dry Pavement
- Operating on Grades and Dry Pavement
- Tips for Operation on Slick Roads
- Engine Maintenance
- Maintenance Requirements
- Maintenance Schedule Intervals
- Preventative Maintenance Schedule
- Engine Specifications
- Engine Lubricating Oil Recommendations and Specifications
- Engine Oil Capacities and Pressures
- Engine Lubrication and Filter Intervals
- Cooling System Maintenance
- Engine Coolant Specifications
- Extended Life Coolant
- Fuel Recommendations
- Warranty and the Use of Biodiesel Fuel
- Recommendations to Avoid Fuel Gelling
- Fuel Filter Interval
- Diesel Exhaust Fluid Recommendations and Specifications
- Maintenance Procedures
- Engine Identification
- Engine Warranty
- Index
1. Place the new poly V-belt over the
pulleys, making certain the belt falls
into all the belt pulley grooves.
NOTE
When installing the belts do not
wrap belt around the tensioner
until after the belt has been
wrapped around all other pulleys
and idlers.
2. After installing the belt, carefully
allow the belt tensioner to spring
back to its normal position. If the
tensioner had been temporarily
blocked, relieve tensioner pressure
enough to remove the locking pin,
then allow the tensioner to spring
back to its normal position.
NOTE
Do not reuse nylon patch lock
nuts. Replace with new lock nuts
when reinstalling parts.
3. Reinstall fan blade using fan blade
bolts and new 9/16 in. nylon patch
lock nuts.
4. Reconnect the electrical ground wire
to the battery.
Diesel Exhaust Fluid (DEF) Filter
Maintenance tasks for diesel exhaust fluid
filter
Perform these maintenance procedures
according to the Preventative Maintenance
Schedule.
ENGINE MAINTENANCE - Maintenance Procedures
Y53-1183-1E1 (04/16/18) 69
2