operators_manual
Table Of Contents
- Contents
- Engine Operation
- Safety - Introduction
- Emergency - What To Do If
- Operating Instructions
- Engine Maintenance
- Maintenance Requirements
- Maintenance Schedule
- Engine Specifications
- Engine Lubricating Oil Recommendations and Specifications
- Engine Oil Specifications
- Engine Lubrication and Filter Intervals
- Cooling System Maintenance
- Engine Coolant Specifications
- Extended Life Coolant
- Fuel Recommendations
- Warranty and the Use of Biodiesel Fuel
- Recommendations to Avoid Fuel Gelling
- Maintenance Procedures
- Engine Oil Level
- Engine Oil Filter
- Crankcase Ventilation (CCV) Module Maintenance
- Fuel Filter
- Cooling System
- Drive Belts
- Engine Belt Checks
- Fan Belt Tensioner
- Engine Fan
- Poly V-belt and Fan Drive Belt Removal
- Poly V-belt and Fan Drive Belt Installation
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Removal
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Install
- Aftertreatment System
- Air System
- Air Intake System
- Turbocharger
- Exhaust System
- Charging - Cranking System
- Crankshaft - Vibration Damper
- Engine Mounting Bolts
- Engine Valves
- Engine Identification
- Engine Warranty
- Index
cap to 30 lb-ft (40 N·m) as
specified on the filter cap.
Fuel Filter Module - Priming Pump
4. Replace the chassis-mounted fuel
filter per the filter manufacturer's
recommended procedure.
NOTE
If your vehicle is equipped with a PAC-
CAR fuel blending
valve, rotate the
blending shut-off valve to the PRIME
(closed) position before starting the
priming procedure.
5. If vehicle is equipped with a fuel
blending valve, rotate the valve to
the RUN/open position.
NOTE
Allowing the engine to idle for several
minutes with the
fuel blending valve in
the prime postition assists in purging
air from the fuel system.
Starting After the Fuel Tank Has
Run Dry or After Fuel System
Service has been Performed
Procedure for starting the engine after
running out of fuel.
Follow the steps below to restart the
engine:
CAUTION
The following instructions should only
be used in
emergency situations when
the fuel tank has run dry. Failure to fol-
low the starting instructions below may
damage the starter motor.
Fuel Filter Module - Priming Pump
ENGINE MAINTENANCE - Maintenance Procedures
Y53-1181-1K1 (08/2018) 61
2