operators_manual
Table Of Contents
- Contents
- Engine Operation
- Safety - Introduction
- Emergency - What To Do If
- Operating Instructions
- Engine Maintenance
- Maintenance Requirements
- Maintenance Schedule
- Engine Specifications
- Engine Lubricating Oil Recommendations and Specifications
- Engine Oil Specifications
- Engine Lubrication and Filter Intervals
- Cooling System Maintenance
- Engine Coolant Specifications
- Extended Life Coolant
- Fuel Recommendations
- Warranty and the Use of Biodiesel Fuel
- Recommendations to Avoid Fuel Gelling
- Maintenance Procedures
- Engine Oil Level
- Engine Oil Filter
- Crankcase Ventilation (CCV) Module Maintenance
- Fuel Filter
- Cooling System
- Drive Belts
- Engine Belt Checks
- Fan Belt Tensioner
- Engine Fan
- Poly V-belt and Fan Drive Belt Removal
- Poly V-belt and Fan Drive Belt Installation
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Removal
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Install
- Aftertreatment System
- Air System
- Air Intake System
- Turbocharger
- Exhaust System
- Charging - Cranking System
- Crankshaft - Vibration Damper
- Engine Mounting Bolts
- Engine Valves
- Engine Identification
- Engine Warranty
- Index
3. Clean the CCV module and
surrounding area to avoid dirt
contaminating the module.
NOTE
Keep the new CCV module in its pack-
aging until it's
time to install it to the
engine.
4. Disconnect the electrical connector
and outlet hose.
Serviceable CCV - MX-13, Front
5. Remove the CCV module by
unscrewing the six bolts using a
ratchet with 13 mm socket.
NOTE
Be careful when removing the CCV to
prevent an oil
spill. Oil may be present
in the CCV-to-engine interface.
6. Wipe the on-engine sealing
interface with a clean, lint-free rag
(not shown). Remove old face
gasket.
CCV - MX-13 Mounting
1
How to Disassemble a CCV
Disassembly instructions for servicable
Crankcase Ventilation (CCV) modules.
Ensure that you have followed these steps
How to Remove a Crankcase Ventilation
Module on page
55 before proceeding with
disassembling the unit.
Follow the steps below to disassemble the
CCV to access to the replaceable filter and
gaskets.
1. Lay the CCV module on a clean
table with the engine interface
facing down.
ENGINE MAINTENANCE - Maintenance Procedures
56 Y53-1181-1K1 (08/2018)
2