operators_manual

Centrifugal Bypass Oil Filter
Installation
Procedure to intall the centrifugal bypass
oil filter on PACCAR MX-13 engines.
Follow the steps below to install the
centrifugal bypass oil filter:
Centrifugal Bypass Oil Filter Installation
1
2
3
1. Lightly lubricate the new O-ring (1)
with engine oil.
2. Fit the new O-ring (1) onto the cap
(2).
3. Mount the centrifugal filter (3) with
its top side in the bearing of the
screw cap (2).
4.
Check to ensure the centrifugal
filter (3) can rotate freely.
5. Position the screw cap carefully
onto the oil module.
6. Tighten the screw cap by hand until
it reaches the end position.
7.
Tighten the screw cap to 30 lb-ft
(40 N·m). Use a hexagonal socket,
or box wrench, to avoid damaging
the oil filter cap.
Full-flow Oil Filter Removal
Procedure for removing full-flow oil filter on
PACCAR MX-13 engines.
Full-flow Oil Filter Module
1. Unscrew the cap a few turns and
drain the filter housing. Use a
hexagonal socket, or box wrench,
to avoid damaging the oil filter cap.
2. Remove the cap, with the oil filter
cartridge, from the filter housing.
Then remove the oil filter cartridge
from the screw cap.
3. Remove the O-ring from the screw
cap.
WARNING
Lubricating oil can cause skin irritation
or skin injury
. To prevent skin injury,
avoid unnecessary contact with the lu-
bricating oil. Wear protective clothing,
eye wear and gloves when handling
lubricating oil. Failure to comply may
result in personal injury.
Full-flow Oil Filter Installation
Procedure for installing full-flow oil filter on
PACCAR MX-13 engines.
Use the following procedure to install full-
flow oil filters.
1. Lightly oil the new O-ring.
2. Install the new O-ring onto the
screw cap.
3. Install the screw cap, with the oil
filter cartridge, onto the filter
housing. Tighten the screw cap to
30 lb-ft (40 N·m). Use a hexagonal
socket to avoid damaging the oil
filter cap.
ENGINE MAINTENANCE - Maintenance Procedures
54 Y53-1181-1K1 (08/2018)
2