operators_manual

CCV Motor/Filter Assembly
Fit onto Shaft
Turn to Slide Ensure Shaft Protrudes
1
1. Install the new O-ring gasket on the
motor and the new face gasket on
the CCV-to-engine interface of the
CCV housing. Lubricate the two
gaskets with clean engine oil.
2. Orient the motor so that the shaft is
facing upward.
3.
Take the new filter assembly out of
its packaging, fit it on the shaft and
turn it so that it slides into the notch
and shaft protrudes through the
end of the filter.
4. Install the motor with the new filter
in the housing in horizontal
position. When reinstalling motor,
ensure shaft and bottom bearing
are aligned (1).
CAUTION
DO NOT force motor into the CCV
housing, or damage
to the bottom
bearing may occur.
5. Tighten and torque the four bolts
(1) using a torque wrench to 70.8
+/- 8.4 lb-in. (8.0 +/- 1.0 N·m).
CCV Filter/Motor Installation
1
3
2
1. Housing
2. Motor
3. Mounting Flange
ENGINE MAINTENANCE - Maintenance Procedures
Y53-1166-1G1 (08/2018) 59
2