operators_manual

Module on page 56 before proceeding with
disassembling the unit.
Follow the steps below to disassemble the
CCV to access to the replaceable filter and
gaskets.
1. Lay the CCV module on a clean
table with the engine interface
facing down.
2. Unscrew the four bolts (1) using a
ratchet with 10 mm socket.
CCV Filter/Motor Installation
1
3
2
1. Housing
2. Motor
3. Mounting Flange
3.
Remove the motor from the
housing and take out the filter.
Do not remove the retaining ring e-clip
from the shaft. The e-clip (1) being slanted
is OK (2).
CCV Retainer Ring Installation
1
2
4. Remove the gasket from the motor
as well as the gasket from the
housing, and wipe the two gasket
grooves with a clean, lint-free rag.
5. Properly dispose of the filter and
gaskets.
How to Reassemble a CCV Unit
Reassembly instructions for servicable
Crankcase Ventilation (CCV) modules
Follow the steps below to reassemble the
CCV after the old filter and gaskets have
been removed.
ENGINE MAINTENANCE - Maintenance Procedures
58 Y53-1166-1G1 (08/2018)
2