operators_manual
Table Of Contents
- Contents
- Engine Operation
- Safety - Introduction
- Emergency - What To Do If
- Operating Instructions
- Engine Maintenance
- Maintenance Requirements
- Maintenance Schedule
- Engine Specifications
- Engine Lubricating Oil Recommendations and Specifications
- Engine Oil Specifications
- Engine Lubrication and Filter Intervals
- Cooling System Maintenance
- Engine Coolant Specifications
- Extended Life Coolant
- Fuel Recommendations
- Warranty and the Use of Biodiesel Fuel
- Recommendations to Avoid Fuel Gelling
- Maintenance Procedures
- Engine Oil Level
- Engine Oil Filter
- Crankcase Ventilation (CCV) Module Maintenance
- Fuel Filter
- Cooling System
- Drive Belts
- Engine Belt Checks
- Fan Belt Tensioner
- Engine Fan
- Poly V-belt and Fan Drive Belt Removal
- Poly V-belt and Fan Drive Belt Installation
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Removal
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Install
- Aftertreatment System
- Air System
- Air Intake System
- Turbocharger
- Exhaust System
- Charging - Cranking System
- Crankshaft - Vibration Damper
- Engine Mounting Bolts
- Engine Valves
- Engine Identification
- Engine Warranty
- Index
3. Clean the CCV module and
surrounding area to avoid dirt
contaminating the module.
NOTE
Keep the new CCV module in its pack-
aging until it's
time to install it to the
engine.
4. Disconnect the electrical connector
and outlet hose.
Serviceable CCV - MX-11, Front
5. Remove the CCV module by
unscrewing the six bolts using a
ratchet with 13 mm socket.
NOTE
Be careful when removing the CCV to
prevent an oil
spill. Oil may be present
in the CCV-to-engine interface.
6. Wipe the on-engine sealing
interface with a clean, lint-free rag
(not shown). Remove old face
gasket.
CCV - MX-11 Mounting
1
How to Disassemble a CCV
Disassembly instructions for servicable
Crankcase Ventilation (CCV) modules.
Ensure that you have followed these steps
How to Remove a Crankcase Ventilation
ENGINE MAINTENANCE - Maintenance Procedures
Y53-1166-1G1 (08/2018) 57
2