operators_manual

After Replacing Engine Oil Filter(s)
Procedure for what to do after installing
new oil filters.
Follow the steps below after installing new
oil filters:
1. Reconnect the chassis battery
cable at the negative battery
terminal. See "Oil Filter Removal
Preparation."
2. Add approved engine oil to the
maximum level marked on the
dipstick. If the engine is running a
dif
ferent weight of oil, be sure to
top-off the engine oil with the same
brand and viscosity of oil.
3. Start and run the engine for 5 to 10
minutes and check for any oil
leaks.
4. Remove oil collection pan and
dispose of any spillage properly.
5. Shut down the engine and check
engine oil level and top up as
necessary. See "Engine Oil Level."
Crankcase Ventilation (CCV)
Module Maintenance
Servicing the CCV module.
This engine may be equipped with a
servicable Crankcase Ventiflation Module
(CCV). This emissions related component
separates oil from air coming from the
crank case vent. The unit sends the
extracted oil back into the engine and
provides clean vent air back into the air
intake.
See the images below of the serviceable
CCV. If the CCV on your engine does not
match these images then your CCV is not
servicable. If your CCV appears like these
images, then remove and replace the filter
and O-ring gaskets at the prescribed
maintenance interval.
Serviceable CCV
Non Serviceable CCV
How to Remove a Crankcase
Ventilation Module
Maintenance instructions for servicable
Crankcase Ventilation (CCV) modules.
Follow the steps below to remove the CCV
.
1. Disconnect the chassis battery
cable at the negative battery
terminal.
2. Place an oil collection pan directly
under the CCV module.
ENGINE MAINTENANCE - Maintenance Procedures
56 Y53-1166-1G1 (08/2018)
2