operators_manual

4. Press the clips (1) and dismount
the centrifugal oil filter element
from the centrifuge base.
Removing Centrifugal Oil Filter
11
2
5. Remove the O-rings from the
screw cap and centrifuge base.
6. Turn the lower cap ¼ turn to
release the cap.
7.
Remove the O-ring from the lower
cap.
8. Remove the full-flow oil filter from
the oil module.
Removing Full-flow Oil Filter
WARNING
Lubricating oil can cause skin irritation
or skin injury
. To prevent skin injury,
avoid unnecessary contact with the lu-
bricating oil. Wear protective clothing,
eye wear and gloves when handling
lubricating oil. Failure to comply may
result in personal injury.
Oil Filter Installation
Procedure for installing oil filter on
PACCAR MX-11 engines.
Use the following procedure to install oil
filters.
1.
Install the new full-flow oil filter
element into the oil module.
Installing Full-flow Oil Filter
2. Using engine oil, lightly lubricate
the new O-ring for the lower cap.
3. Install the new O-ring onto the
lower cap.
4. T
ighten the lower cap ¼ turn to
lock the full-flow oil filter in place.
ENGINE MAINTENANCE - Maintenance Procedures
54 Y53-1166-1G1 (08/2018)
2