operators_manual
Table Of Contents
- Contents
- Engine Operation
- Safety - Introduction
- Emergency - What To Do If
- Operating Instructions
- Engine Maintenance
- Maintenance Requirements
- Maintenance Schedule
- Engine Specifications
- Engine Lubricating Oil Recommendations and Specifications
- Engine Oil Specifications
- Engine Lubrication and Filter Intervals
- Cooling System Maintenance
- Engine Coolant Specifications
- Extended Life Coolant
- Fuel Recommendations
- Warranty and the Use of Biodiesel Fuel
- Recommendations to Avoid Fuel Gelling
- Maintenance Procedures
- Engine Oil Level
- Engine Oil Filter
- Crankcase Ventilation (CCV) Module Maintenance
- Fuel Filter
- Cooling System
- Drive Belts
- Engine Belt Checks
- Fan Belt Tensioner
- Engine Fan
- Poly V-belt and Fan Drive Belt Removal
- Poly V-belt and Fan Drive Belt Installation
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Removal
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Install
- Aftertreatment System
- Air System
- Air Intake System
- Turbocharger
- Exhaust System
- Charging - Cranking System
- Crankshaft - Vibration Damper
- Engine Mounting Bolts
- Engine Valves
- Engine Identification
- Engine Warranty
- Index
WARNING
Electrical shock hazard: Never discon-
nect the battery
clamp when the en-
gine is running. Disconnecting the bat-
tery clamps while the engine is running
may result in death, personal injury or
equipment damage from electrical arc-
ing or damage to electrical compo-
nents.
1. Disconnect the chassis battery
cable at the negative battery
terminal.
2. Place an oil collection pan directly
under the oil filter.
Oil Filter Removal
Procedure for removing the oil filter on
P
ACCAR MX-11 engines.
1. Clean the oil filter cap and
surrounding area to ensure dirt
does not fall into the oil filter
module.
CAUTION
Dirt in the engine oil lubrication system
can lead to
significant damage to the
engine. Failure to comply may result in
equipment or property damage.
2. Remove the screw cap with the
centrifugal oil filter from the oil
module. Use a hexagonal socket or
a box wrench to avoid damaging
the oil filter cap.
Removing Oil Filter Cap
3. Turn the screw cap clockwise to
unlock the centrifuge base.
Unlocking the Centrifuge Base
ENGINE MAINTENANCE - Maintenance Procedures
Y53-1166-1G1 (08/2018) 53
2