operators_manual
Table Of Contents
- Contents
- Engine Operation
- Safety - Introduction
- Emergency - What To Do If
- Operating Instructions
- Engine Maintenance
- Maintenance Requirements
- Maintenance Schedule
- Engine Specifications
- Engine Lubricating Oil Recommendations and Specifications
- Engine Oil Specifications
- Engine Lubrication and Filter Intervals
- Cooling System Maintenance
- Engine Coolant Specifications
- Extended Life Coolant
- Fuel Recommendations
- Warranty and the Use of Biodiesel Fuel
- Recommendations to Avoid Fuel Gelling
- Maintenance Procedures
- Engine Oil Level
- Engine Oil Filter
- Crankcase Ventilation (CCV) Module Maintenance
- Fuel Filter
- Cooling System
- Drive Belts
- Engine Belt Checks
- Fan Belt Tensioner
- Engine Fan
- Poly V-belt and Fan Drive Belt Removal
- Poly V-belt and Fan Drive Belt Installation
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Removal
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Install
- Aftertreatment System
- Air System
- Air Intake System
- Turbocharger
- Exhaust System
- Charging - Cranking System
- Crankshaft - Vibration Damper
- Engine Mounting Bolts
- Engine Valves
- Engine Identification
- Engine Warranty
- Index
Oil Drain Plug for Composite Pan
What to do after draining oil.
After draining the oil, replace the drain plug
if:
Oil Pan Drain Plug Installation
1
1. Stop
• The plug is leaking.
• The O-ring is missing.
•
The plug/O-ring assembly is
damaged.
• The retention detent cannot be felt
during installation.
Torque the drain plug to its stop.
Oil Drain Plug Detent
1
1. Detent
NOTE
This engine is equipped with a compo-
site oil pan
and drain plug. Care
should be taken to avoid over-torquing
the drain plug.
ENGINE MAINTENANCE - Maintenance Procedures
Y53-1166-1G1 (08/2018) 51
2