operators_manual
Table Of Contents
- Contents
- Engine Operation
- Safety - Introduction
- Emergency - What To Do If
- Operating Instructions
- Engine Maintenance
- Maintenance Requirements
- Maintenance Schedule
- Engine Specifications
- Engine Lubricating Oil Recommendations and Specifications
- Engine Oil Specifications
- Engine Lubrication and Filter Intervals
- Cooling System Maintenance
- Engine Coolant Specifications
- Extended Life Coolant
- Fuel Recommendations
- Warranty and the Use of Biodiesel Fuel
- Recommendations to Avoid Fuel Gelling
- Maintenance Procedures
- Engine Oil Level
- Engine Oil Filter
- Crankcase Ventilation (CCV) Module Maintenance
- Fuel Filter
- Cooling System
- Drive Belts
- Engine Belt Checks
- Fan Belt Tensioner
- Engine Fan
- Poly V-belt and Fan Drive Belt Removal
- Poly V-belt and Fan Drive Belt Installation
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Removal
- Poly V-belt, Alternator, Air-Conditioning Compressor Drive and Coolant Pump Drive Install
- Aftertreatment System
- Air System
- Air Intake System
- Turbocharger
- Exhaust System
- Charging - Cranking System
- Crankshaft - Vibration Damper
- Engine Mounting Bolts
- Engine Valves
- Engine Identification
- Engine Warranty
- Index
Oil Level Indication on Dipstick
High and low marks on the dipstick indicate
level of oil in the oil pan.
NOTE
On the engine oil dipstick, the differ-
ence between the
low oil level mark
(2) and high oil level mark (1) is 9.5
US quarts (9 liters).
Engine Oil Dip Stick Markings
1
2
1. High oil level (1)
2. Low oil level (2)
Topping Up the Engine Oil
Steps for topping up the engine oil.
If checking the engine oil just after stopping
the engine, wait 15 minutes for the oil to
drain back into the oil pan before checking
the fluid level.
This procedure should be followed when oil
level is low and more oil needs to be
added.
1.
Top up with oil, if necessary, via the
filler opening. Use the correct
grade in the correct quantity.
2. After topping up, wait one minute
and check the oil level again.
3. Reinstall the oil fill cap and twist to
lock it in place.
NOTE
See Lubricating Oil Recommendations
and Specifications..
Engine Oil Fill Location
ENGINE MAINTENANCE - Maintenance Procedures
50 Y53-1166-1G1 (08/2018)
2