operators_manual

You may see this appear if the system has
detected a situation where the starter is too
hot and needs to cool down. Alternatively,
you may see it when the engine grid heater
is on and needs some time to warm up.
(PACCAR PX and Cummins ISL engines)
NOTE
Some engines are equipped with an
engine starting motor protection fea-
ture. If the starting motor is engaged
for 30 or more seconds, without the
engine starting, the starter will be
locked out from operating, allowing for
proper cooling of the starting motor.
During this time, the 'Wait-To-Start'
lamp will flash for 2 minutes. Once the
lamp stops flashing, the starting motor
will be allowed to function.
NOTE
Engines equipped with air starting mo-
tors require a minimum of 70 psi (480
kPa).
Fuel Water In Fuel (WIF)
Illuminates when water has been detected
in the fuel.
Lights, High Beam
Illuminates when the high beams are on.
This icon will flash with audible alarm if the
headlamps are left ON when the door is
opened and the key switch is OFF.
In addition, this icon will flash, but without
an audible alarm, if there is a problem with
the low beam headlights or the low beam
headlight wiring. In such event, the high
beam headlights will turn on at 50% normal
brightness.
Lane Departure Warning (LDW)
Illuminates when optional LDW system is
not able to track the vehicle's position
within the lane.
NOTE
For vehicles equipped with Lane De-
parture Warning, please refer to Lane
Departure Warning Driver's Guide for
additional information.
Power Take-off (PTO) Pump Mode
Illuminates with remote throttle application.
Indicates pump mode is active.
Power Take-off (PTO)
Illuminates when the PTO is engaged.
CONTROLS - Guide to the Warning Symbols
Y53-6047-2HEN (03/18) 83
3