operators_manual

• The Stability Control Icon (ESC or
Electronic Stability Control)
illuminates during the power-on self
test when the ignition is turned ON.
It turns off after a few seconds if no
system problems are detected. If a
problem is detected, the ESC
Warning lamp will turn on and stay
on.
• Illuminates when the ESC system
is regulating individual wheel
brakes to correct the vehicle’s
direction of travel. (Refer to
Advanced ABS with Stability
Control for more information.)
WARNING
If this chassis is equipped with an
electronic stability control (ESC) and is
modified (e.g. adding or removing an
axle, converting from a truck to a trac-
tor, converting from a tractor to a truck,
changing the body, lengthening of the
wheelbase and/or frame, relocating
frame components, or modifying pneu-
matic or electrical ABS/ESC harness-
es) the ESC must be disabled by a
qualified technician. If you have any
questions, contact your authorized
dealer. Failure to comply may result in
death, personal injury, equipment or
property damage.
NOTE
For more information about the stabili-
ty control system installed on your ve-
hicle, please refer to additional materi-
al supplied with this operator manual,
included in your glove box information-
al packet.
Axle, Traction Control
Monitors wheel speed for poor traction. If a
wheel begins to slip due to poor traction, it
may reduce engine power or apply brakes
in an effort to regain traction.
• Illuminates during the power-on
self-test when the ignition is turned
ON. It turns off after a few seconds
if no system problems are
detected. If an ATC problem is
detected, the ATC warning lamp
will turn on and stay on.
• Illuminates when the ATC is
regulating wheel spin and turns off
after the traction control event has
ended.
• Flashes continuously when the
ATC/ Deep Snow & Mud switch is
turned on, indicating that this
feature is active.
WARNING
If this chassis is equipped with an
electronic stability control (ESC) and is
modified (e.g. adding or removing an
axle, converting from a truck to a trac-
tor, converting from a tractor to a truck,
changing the body, lengthening of the
wheelbase and/or frame, relocating
frame components, or modifying pneu-
matic or electrical ABS/ESC harness-
es) the ESC must be disabled by a
qualified technician. If you have any
questions, contact your authorized
dealer. Failure to comply may result in
death, personal injury, equipment or
property damage.
CONTROLS - Guide to the Warning Symbols
78 Y53-6047-2HEN (03/18)
3